Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

PDE boundary conditions

Please login with a confirmed email address before reporting spam

I am trying to model water absorption/desorption in a polymer (d1) through an adjacent boundary domain (d2) through a PDE. The absorption and desorption rates (rab & rdes) are specified in relation to an equilibrium level l0 (l303). Within a time dependent analysis this equilibrium is increased for a certain period of time and the real level l slowly follows. However, when reaching equilibrium after about 0.7 s and the absorption rate actually drops to zero the real level l still increases although it should level out (the desorption which should result in the opposite lowering the equilibrium level is disabled at the moment).

I cannot figure out, why this is happening. It does not seem to be an issue of the acting diffusion part in the PDE itself, as the level is increasing in both the boundary domain and the pure polymer. As this is the first time I am setting up an own PDE, I am not entirely sure if I miss out on something considering the boundary conditions.

Thanks a lot,
Matthias


0 Replies Last Post Mar 16, 2012, 8:16 p.m. EDT
COMSOL Moderator

Hello Matthias Weiland

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.