J. Rojo, S. Ognier, and S. Cavadias
Laboratoire de Génie des Procédés Plasmas et Traitements de Surfaces, University Pierre et Marie Curie, Paris, France
A lot of techniques are developed to treat soils polluted by hydrocarbons pollutants: incineration, thermal treatment, extraction, chemical oxidation, bioremediation… Some of these techniques are very energy consuming (incineration, thermal treatment…) and often need a subsequent treatment of the generated gases or liquids. Of all the decontamination methods, bioremediation appears to be the ...
M. Antczak, P. Idziak, and W. Lyskawiski
Poznań University of Technology, Poland
The paper presents the results of the experiment consisting in determination of the influence of the magnetic field on deformations of the stator and the rotor of the DC motor. The numerical model of the motor for the frameless DC machine of the G series has been elaborated. Real material properties and the phenomenon of the magnetic circuit saturation have been taken into consideration. The ...
C. Wolluschek, F. Etcheverry, M. Cachile, and J. Gomba
Mecánica de Fluidos e Ingeniería Térmica, Centro tecnológico Cemitec, Noáin, Navarra, Spain
Grupo de Medios Porosos, Facultad de Ingeniería, UBA, Buenos Aires, Argentina
Instituto de Física Arroyo Seco, UNCPBA, Tandil, Argentina.
In this work, a COMSOL model that predicts velocity and concentration fields inside an X-shaped millichannel (4 mm diameter) is developed. Water and a ink low concentration are injected simultaneously in the two inlets of the device. The mass transfer problem is solved by a Fickian model (solute concentration is low compared with the solvent). The parameters in this study are: initial inlet mass ...
AkerSolutions, Fornebu, Norway
In COMSOL Multiphysics it is possible to implement and simulate several independent models in parallel. This can be meaningful when the different models are coupled to each other by some kind of interaction. If a part of the geometries is identical in all models, this part can be reduced in that it is implemented in only one of the geometries. In the other geometries only its solution towards ...
Center for Product Development, Mads Clausen Institute, South Danish University, Denmark
This paper will give a short overview of use of COMSOL Multiphysics for analyzing ancient Greek and Roman catapults with the main focus on the energy storing torsion springs. Catapults have been known and used in the Greek and Roman world from around 399 BC and a fully standardized design for powerful torsion catapults emerged around 270 BC, based on one basic factor, the diameter of the torsion ...