Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Why do Boundary Probe Point Coordinates change in Results

Please login with a confirmed email address before reporting spam

Hello to all,

I have encountered an issue with Boundary Point Probes:

I have a code that creates Boundary Point probes (around 100) on a surface at evenly idstributed inervals on the Y direction (X and Z are constant) - I also specify the Expression and which Boundary it should belong. This works very well and if I clock on each probe I see the red dot moving on the surface boundary. I have also grouped the probes fo better handling.

The problem is that in the Definitons part of the model the coordinates are maintained (i.e. are what they suppose to be) for all probes, but in the Results part half of the probes have their X Y Z coordinates set to 0, 0, 0.

Now this is a big problem because I get NaNs for those probes.

Does anybody have an explination for this? Can it be a software bug?

Kidn regards, Ion


0 Replies Last Post May 3, 2019, 10:24 a.m. EDT
COMSOL Moderator

Hello Ion Candel

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.